Device replacement LOCON 7 & 9

Aus Deutschmann Wiki
Zur Navigation springen Zur Suche springen

LOCON 7 and LOCON 9 will be available only until 31.12.2014. Depending on the version used, LOCON 7 can be replaced after cancellation by a corresponding LOCON 16, LOCON 17, LOCON 24, LOCON 90, LOCON 100, LOCON 200, ROTARNOCK 80 or ROTARNOCK 100. In order to ensure a proper and fast replacement, we would need the following information and components:

  1. The serial-no. or the article-no.(Vxxxx) of the old device has to be known in order to offer a corresponding new device.
  2. If a TERM 6 or a TERM 24 is already under use, we have to know the serial-no. of this device in order to check the compatibilty with the new LOCON or ROTARNOCK.
  3. For the configuration and programming of the new device with WINLOC 32-Basic-or Comfortversion would be needed a corresponding programming cable. Note: It has to be checked in every single case if this programming cable may be used also for a needed reading of the old device.
  4. If a configuration of the new device has to be done, then would be needed a TERM 6 or WINLOC 32-Basic-or Comfortversion.
  5. For the configuration and programming of the new device with WINLOC 32-Basic-or-comfort Version, the PC is in need of a real COM-Port. If there exists no more real COM-Port at the PC, then a USB-to-RS232 converter has to be used.

For a corresponding offer please let us know the serial-no. or the article-no. (Vxxxx) of the old device and, in case, the serial-no. of an already used TERM 6 resp. TERM 24.