868
Bearbeitungen
Änderungen
Zur Navigation springen
Zur Suche springen
Device replacement ROTARNOCK - PROFIBUS (English) (Quelltext anzeigen)
Version vom 18. Dezember 2017, 11:56 Uhr
, 11:56, 18. Dez. 2017→Device Configuration
The configuration has to be done with our software [[WINLOC 32 (English)|WINLOC 32]]-Basis-or Comfortversion. Herefore is needed a corresponding [[Programming cable]]. '''Note:''' If this programming cable should be used for a needed read out of the old device then this has to be checked separately. '''Attention:''' For the configuration, the PC is in need of a real COM-Port. If there is no real COM-Port at the PC, then a [[USB-to-RS232 converter]] has to be used.
*'''Virtual encoder resolution:''' If the cam values of the existing electronic cam control should be reused in the new data block, the virtual encoder resolution must be changed to the value of the existing electronic cam control.
*'''Type of idle time compensation:''' Damit die Totzeiten der vorhandenen elektronischen Nockensteuerung im neuen Datenbaustein wiederverwendet werden könnenIf the idle times of the existing electronic cam control should be reused in the new data block, muss die Art der Totzeit then the type of idle time (BitweiseBitwise; BlockweiseBlockwise; ...) auf die von der vorhandenen elektronischen Nockensteuerung verwendeten Art geändert werdenhas to be set accordingly.*'''PROFIBUS-Slave-ID:''' Die gewünschte The desired PROFIBUS-Slave-ID muss mit der Software has to be set via WINLOC 32 eingestellt werdensoftware, wenn diese nicht über den if this if this is not to be assigned via the PROFIBUS-Master zugewiesen werden sollmaster. Im Auslieferungszustand ist die The PROFIBUS-Slave-ID auf is set to 126 eingestelltat delivery state.*'''Operation modes:''' In conjunction with a PROFIBUS-Master this must be set to '''S7-mode''' . This S7-mode is already set in the at delivery state.
*'''Logic function:''' If the logic function is used in the old device then this function has to be unlocked for ROTARNOCK 100-PB. Therefore a chargeable release code is needed. '''Attention:''' This release code is bounded to the serial-no. and can not be used for other cam controls.
