Änderungen

Zur Navigation springen Zur Suche springen
==Device Configuration==
The configuration has to be done with our software [[WINLOC 32 (English)|WINLOC 32]]-Basis-or ComfortversionComfort version. Herefore is needed a corresponding [[Programming cable]]. '''Note:''' Whether the programming cable can also be used for a necessary read-out of the old device has to be tested in each case! '''Attention:''' For the configuration, the PC is in need of a real COM-Port. If there is no real COM-Port at the PC, then an [[USB-to-RS232 converter]] has to be used.
*'''Virtual encoder resolution:''' If the cam values of the existing electronic cam control should be reused in the new data block, the virtual encoder resolution must be changed to the value of the existing electronic cam control.
*'''Type of idle time compensation:''' If the idle time of the existing electronic cam control should be reused in the new data block, then the type of idle time (Bitwise; Blockwise; ...) has to be set accordingly.
868

Bearbeitungen

Navigationsmenü