Device replacement ROTARNOCK 1, 2, 3 and 4 (English)
Zur Navigation springen
Zur Suche springen
Rotarnock 1,2,3 and 4 as well as the corresponding PROFIBUS variants were replaced by ROTARNOCK 100. This is available with or without PROFIBUS. The following information and components are needed to guarantee a quick exchange and programming of the new device:
- The serial number or the article number (Vxxxx) of the old device have to be known to ensure that an appropriate new device can be offered.
- If a TERM 6 or a TERM 24 is already in use, we also need to know the serial number of this device to check the compatibility with the new device. Note: TERM 5 and TERM 32 are not compatible with ROTARNOCK 100!
- To read-out the old device and possibly for the configuration and programming of the new device with the WINLOC32-Basis-or comfort-version, a corresponding Programming cable is needed. Note: Whether the programming cable can also be used for a necessary read-out of the old device has to be tested in each case!
- A TERM 6 or the WINLOC32-Basis or comfort-version is needed for the configuration of the new device.
- There has to be a real COM-Port on the PC for the configuration and programming of the new device with WINLOC32. If there is no real COM-Port on the PC, you need a USB-RS232-converter.
Programming - zero offset - program selection
- The programming of the new device can be performed with TERM 6, TERM 24 or with the WINLOC32-Basis or comfort-version. With the PROFIBUS version you can also program via PROFIBUS.
- The zero offset can be performed with TERM 6, TERM 24 or with the WINLOC32-comfort-version. With the PROFIBUS version you can also program via PROFIBUS.
- The program selection can be done with TERM 6, TERM 24 or via the external program selection. With the PROFIBUS version you can also program via PROFIBUS.
For a corresponding offer please let us know the serial number or the article number (Vxxxx) of the old device and, if used, the serial-no. of TERM 6 resp. TERM 24.