Firmware update: Unterschied zwischen den Versionen
Zur Navigation springen
Zur Suche springen
(Aus dem Deutschen übersetzt) |
|||
Zeile 59: | Zeile 59: | ||
Please follow the steps below to download the firmware: | Please follow the steps below to download the firmware: | ||
# Connect the UNIGATE's application interface (RS-232) with your PC. | # Connect the UNIGATE's application interface (RS-232) with your PC. | ||
− | # Start the Firmware Download Tool and select the serial interface ( | + | # Start the Firmware Download Tool and select the serial interface (Options→Settings) connected to the UNIGATE. |
# | # | ||
#* UNIGATE CL: On the device please set the rotary switches S4 and S5 to "F" (Config mode). | #* UNIGATE CL: On the device please set the rotary switches S4 and S5 to "F" (Config mode). | ||
Zeile 69: | Zeile 69: | ||
# Transmission of the firmware should start now. | # Transmission of the firmware should start now. | ||
− | In the case of a connection loss during the update process please use the button 'Resume Download' instead of 'Firmware Download' for further attempts. | + | In the case of a connection loss during the update process please use the button 'Resume Download' instead of 'Firmware Download' for further attempts. |
== Update via Ethernet == | == Update via Ethernet == |
Version vom 17. Oktober 2013, 13:31 Uhr
In order to load a firmware into your UNIGATE device please use the software Firmware Download Tool. You can find it in our web site's support area.
Depending on the device used the update needs to be carried out via the RS-232 or the Ethernet interface.
Interface | ||
---|---|---|
Device | RS-232 | Ethernet |
PROFIBUS | • | |
PROFINET | • | |
DeviceNet | • | |
EtherNet/IP | • | |
CANopen | • | |
EtherCAT | • | |
Ethernet TCP/IP | • | |
ModbusRTU | • | |
ModbusTCP | • | |
RS (232/485/422) | • | |
BACnet/IP | • |
Update via RS-232
Please follow the steps below to download the firmware:
- Connect the UNIGATE's application interface (RS-232) with your PC.
- Start the Firmware Download Tool and select the serial interface (Options→Settings) connected to the UNIGATE.
-
- UNIGATE CL: On the device please set the rotary switches S4 and S5 to "F" (Config mode).
- UNIGATE IC/FC: On the developer board please set the mode switch to "Config".
- Now start the device. A start-up message will appear in the Firmware Download Tool.
- Select 'Firmware Download' and confirm the warning.
- Select the firmware file (file type HEX), select 'Open', then 'OK'.
- Select a Baud rate.
- Transmission of the firmware should start now.
In the case of a connection loss during the update process please use the button 'Resume Download' instead of 'Firmware Download' for further attempts.
Update via Ethernet
Please follow the steps below to download the firmware:
- Connect your UNIGATE with your PC using either a switch or a hub.
- Run the Firmware Download Tool, press ‘Firmware Download’ and ‘OK’.
- Select the firmware file (type BIN-File) press 'open' and 'OK'.
- Enter the IP-Address of the device.
-
- UNIGATE CL: On the device please set the rotary switches S4 and S5 to „F“ (Config mode).
- UNIGATE IC/FC: On the developer board please set the mode switch to „Config“.
- Press 'Start Download' and restart the device within 20 seconds.
- Transmission of the firmware should start now.