en:Protocol Developer: Unterschied zwischen den Versionen
Reith (Diskussion | Beiträge) |
Reith (Diskussion | Beiträge) |
||
Zeile 10: | Zeile 10: | ||
#Via menue item '''"Options"''' --> '''"Settings"''' the window '''"Settings"''' opens. | #Via menue item '''"Options"''' --> '''"Settings"''' the window '''"Settings"''' opens. | ||
#Here the menue item '''"ConfigFiles"''' has to be selected. | #Here the menue item '''"ConfigFiles"''' has to be selected. | ||
− | #In the following window, the desired configuration file can be selected or loaded via the '' '"add"' '' button and confirmed with the '' '"OK"' '' button. | + | #In the following window, the desired configuration file can be selected or loaded via the '''"add"''' button and confirmed with the '''"OK"''' button. |
#Das nachfolgende Fenster '''(Restart required)''' muss über die Schaltfläche '''"OK"''' bestätigt und der Protocol Developer neu gestartet werden. | #Das nachfolgende Fenster '''(Restart required)''' muss über die Schaltfläche '''"OK"''' bestätigt und der Protocol Developer neu gestartet werden. | ||
Version vom 16. Februar 2017, 11:55 Uhr
Protocol Developer is a programming software for Deutschmann UNIGATE®-devices.
Inhaltsverzeichnis
Debug-Function
With Protocol Developer there is the possibilty to debug the programmed resp. created script. Therefore UNIGATE® has to be started in Data Exchange Mode and has to be connected via Debug-Interface or Application Interface (RS232) with the PC resp. Protocol Developer. Further detailed information is to be found under the link UNIGATE® interfaces.
Add language definition (XML-Datei)
The language range of the Deutschmann Script language is continually expanded. The Script-Revision [...] (number in square brackets after the version specification) indicates which level is supported by the device firmware and the Protocol Developer . The language definition is organized into XML files. New language definitions can be installed in the Protocol Developer as follows.
- Put the XML-file (z. B. ScriptRev*.xml) in the program folder.
- Via menue item "Options" --> "Settings" the window "Settings" opens.
- Here the menue item "ConfigFiles" has to be selected.
- In the following window, the desired configuration file can be selected or loaded via the "add" button and confirmed with the "OK" button.
- Das nachfolgende Fenster (Restart required) muss über die Schaltfläche "OK" bestätigt und der Protocol Developer neu gestartet werden.
Adapt existing script to another Fieldbus or Industrial Ethernet system
Possible procedure:
- The existing script must be compared with the corresponding script template (template) of the Protocol Developer regarding the bus-specific parameters. These are marked in the script templates (Template) with „!!!“.
- Via menu item „File“ -> „New“ -> „Source“ -> „Template“ can be called the corresponding script template.
- If the bus-specific parameters are identical, the script must not be adapted. However this applies only if at the initalization of the bus (:InitFieldbus;) further bus-specific, optional parameters have not been inserted. If this is the case, these optional parameters have to be compared with the appropriate script template (Example) from the Protocol Developer.
- Via menu item „File“ -> „New“ -> „Source“ -> „Example“ -> „Include“ the appropriate script template can be called.
Weblinks
- Protocol Developer (Zip-Datei)