ROTARNOCK 80 (English)

ROTARNOCK 80

Programming

ROTARNOCK 80 can be programmed by TERM 6 or TERM 24 or the software WINLOC 32.In the PROFIBUS-Version the programming is done via PROFIBUS.

Device replacement

• The ROTARNOCK 80 was available until 11.11.2014. Depending on the version used, the ROTARNOCK 80 can be replaced by a corresponding ROTARNOCK 100. You find all needed information on the site

Device replacement ROTARNOCK 80.

• The ROTARNOCK 80 with PROFIBUS interface was available until 11.11.2014. The ROTARNOCK 80 with PROFIBUS interface can be replaced with a ROTARNOCK 100 with PROFIBUS interface. You find all needed information on the site Device replacement ROTARNOCK - PROFIBUS

Weblinks

Manual for ROTARNOCK 80 (PDF-file)