TERM 6 (English)

TERM 6, TERM 6-H and TERM 6-T

Instruction

The operating of TERM 6 is done by the 4-keys of the operating front.

Device Replacement

Each TERM 6 can be replaced by an actual TERM 6 or the configuration and programming software WINLOC 32. In order to ensure a proper and fast replacement, we would need the following information and components:

1. The serial-no. or the article-no.(Vxxxx) of the old device has to be known in order to offer a corresponding TERM 6.
2. We have to know the serial-no. of the used cam control in order to check the compatibilty to the new TERM 6.
3. If the used cam control is not compatible to the new and actual TERM 6, then this cam control has to be replaced, too.
4. For read-out of the used cam control and its programming or, if needed, the configuration and programming of a new cam control with WINLOC32-Basic-or-comfort Version would be needed a corresponding programming cable.
5. For the configuration and programming with WINLOC 32-Basic-or-comfort Version, the PC is in need of a real COM-Port. If there exists no more real COM-Port at the PC, then a USB-to-RS232 converter has to be used.

For a corresponding offer please let us know the serial-no. or the articel-no. (Vxxxx) of the old device and the serial-no. of the used cam control.

Attention: The T and H variants were discontinued in March 2023. A 1:1 replacement and a successor device are not available. Alternatively, the Standard - TERM 6 (article no.: V2000) can be used as an alternative.

Weblinks

Manual for TERM 6 (PDF-file)