2.226
Bearbeitungen
Änderungen
Zur Navigation springen
Zur Suche springen
UNIGATE® Scan (English) (Quelltext anzeigen)
Version vom 5. Dezember 2017, 12:48 Uhr
, 12:48, 5. Dez. 2017→Weblinks
[[Datei:UST.JPG|thumb|UNIGATE® Scan Tool]]
With UNIGATE® Scan Tool (UST) UNIGATE® Fast-Ethernet devices from firmware-version V5.31 can be displayed, which are located in the previously selected IP-adress-range. In Addition addition an IP-adress can be assigned to temporary or permanent.
== Scan-function ==
Please find described below how to find UNIGATE® Fast-Ethernet devices:
''Note'': UNIGATE® Fast-Ethernet devices can be either in '''Konfig.-Mode''' or in '''Run-Mode'''. Only one of the 4 communication channels must not be occupied so that UST can be used. '''Attention:''' If the transport-protocol Modbus TCP of ''Universalscript Deutschmann'' is used, then an UNIGATE® Fast-Ethernet device can '''only''' be scanned in '''Konfig.-Mode'''.
#Install UST and start.
#Through the selection box under '''"Adapter IP"''' are displayed all IP address ranges of the Ethernet Adapters existing on the computer.Here the desired IP address range must be selected for the scan operation.
#Via the button '''"Blink"''' the flash functiom is executed. The '''Bus State LED''' flashes red for about 5 seconds. This is for checking if the marked UNIGATE® Fast-Ethernet device is really the correct one.
#Is the correct UNIGATE® Fast-Ethernet device marked, now an IP-address under '''"IP-Address"''' maybe added and then assigned. This address can be assigned temporarily or permanently. If the IP-address has to be stored permanently in the UNIGATE® Fast-Ethernet device, then first in the box '''"set_perm"''' has to be set a hook. Otherwise, it is set only temporary.
#Via The desired UNIGATE® Fast Ethernet device must be marked again. The IP address is then transferred via the button ''''"Set IP"''' the IP-address is transferred button and set accordingly. #Abschließend sollte das Finally the UNIGATE® Fast-Ethernet Gerät neu gestartet werden und ein erneuter Scan durchgeführt werden um zu überprüfen, ob die zuvor übertragene device should restart and a new scan should be operated in order to check if the previously transmitted IP-Adresse auch korrekt gesetzt worden istaddress has been set correctly. ''HinweisNote'': Wenn die If the IP-Adresse nur temporär gesetzt wirdaddress is set only temporary, there should be done no restart, kann darf das Gerät nicht neu gestartet werden. Der erneute Scan kann direkt nach dem Setzen erfolgenthe new scan should be operated directly after setting of the new IP-address.#FertigDone.
== Weblinks ==
[httphttps://www.deutschmann.de/produktedownloads/downloadSoftware/Beta/DA_Tools/netscan/SetupUNIGATESCAN1_3.php?file_id=702 exe UNIGATE® Scan Tool (UST)] (Zip-Datei)
