ROTARNOCK 80 (English)
Zur Navigation springen
Zur Suche springen
Programming
ROTARNOCK 80 can be programmed by TERM 6 or TERM 24 or the software WINLOC 32.In the PROFIBUS-Version the programming is done via PROFIBUS.
Device replacement
- The ROTARNOCK 80 was available until 11.11.2014. Depending on the version used, the ROTARNOCK 80 can be replaced by a corresponding ROTARNOCK 100. You find all needed information on the site
Device replacement ROTARNOCK 80.
- The ROTARNOCK 80 with PROFIBUS interface was available until 11.11.2014. The ROTARNOCK 80 with PROFIBUS interface can be replaced with a ROTARNOCK 100 with PROFIBUS interface. You find all needed information on the site Device replacement ROTARNOCK - PROFIBUS
Weblinks
Manual for ROTARNOCK 80 (PDF-file)